New Member Restoring an 11CC

[joea]

Roger and James,

If someone is interested in making their own spars, or even just doing their own wings, the thread that Tim did is one of the best I have seen on this.

Well worth the time to take in looking at the steps he took and things that he encountered.

Joe A

Joe. I'm not. However, I concur with that being an excellent thread. With his concurance, wonder if it could be posted in another resource area...if there is such a place. roger

Roger,

Right now its in the "Restoration" section and am open to other ideas as to where to put it. I could flag it and keep it at the top of the section if everyone feels its needed.

It really is a very good bit of information.

Joe

[Nathan K. Hammond]

I could flag it and keep it at the top of the section if everyone feels its needed?

Good idea!

nkh

[Roger Anderson]

Right now its in the "Restoration" section and am open to other ideas as to where to put it. I could flag it and keep it at the top of the section if everyone feels its needed.

It really is a very good bit of information.

Joe

It's such a good presentation, keeping it up front and having persons aware of it, is nice. Also, several others, John Baker's excellent oleo repair presentation comes to mind, are great references. I'm sure there are others of which I'm not familar. I'm not sure how to do it, but having all of this in a central and advertised location might be something to consider, if the authors didn't mind. John's is at the following. roger

http://www.hangar9aeroworks.com/Aeronca ... strut.html

[joea]

Ok guys, its now a "Sticky" at the restoration forum.

Any other suggestions pls fire away. After all, this is YOUR board, I am just the lacky that takes care of it!

Joe

[Bart]

I am a fairly new member, but have not been on the bulletin board until now. I live in the Monroe Area and am restoring an 11CC as well. I would like to vist your project some time if possible.
Bart