Page 2 of 2
Posted: Tue Mar 18, 2008 09:35
by 1quick46
Only the center and outer on the left wing have a spongy side to side motion, approx 1/4 inch. the inner is rigid in all directions.. the right wing is rigid everywhere but the fabric is tight around the brackets.. I will probably cut a access hole this weekend to check the bolts..thanks everybody
Posted: Tue Mar 18, 2008 17:09
by Jody Wittmeyer
When you cut new holes, if you reach in the wing and glue the platic cover ring to the bare fabric on the inside of the wing, you won't have to do any sanding and they hold great. The lid goes on as normal.
Posted: Wed Mar 19, 2008 10:25
by shazam
What Jody said....and (pained voice of humbling experience speaks
) make sure to stay far enough away from the ribs that the rib flange doesn't interfere with gluing it on the inside.
Jim
Posted: Fri Mar 21, 2008 21:27
by 1quick46
Thanks everybody, got inside the wing and I guess I was just nervous.. the looseness was just flex from the bracket..the right wing has no play because the fabric is tight around the bracket..