Page 1 of 1
5 Gal Wing Tank
Posted: Wed Jul 08, 2009 16:31
by 15A
Is there anyone out there willing to ship me a 5 gallon wing tank, at my expense, so I can blue-print it and make a left & right set??? It can be dented or torn. I just need enough of it there to reverse engineer. I'll ship it back when I'm done.
They're for my Champ that's going on floats with a C90.
Then I'm going to be looking for the rear fuselage to strut, clamp-on mounts for Edo 1400's. Same scenario.
Thanks!
JoeCraig@CustomSMP.com
Posted: Wed Jul 22, 2009 12:32
by 15A
Amazing. Not one reply.
Paul had sent me a 13 gal tank that I was going to possibly use, but decided 2 5 gal tanks would be lighter and easier to install.
On the other subject, I have found a rear set of Edo 1400 clamp-on mounts that I'm going to duplicate.
Posted: Wed Jul 22, 2009 12:57
by Jody Wittmeyer
I have a left, but it will be going to MN. first. How about the drawings. We could help you that way.
Posted: Wed Jul 22, 2009 13:05
by 15A
Thanks for the reply Jody!
I wasn't aware prints were available for these tanks. I'm very interested. Where can I get a set of prints?
Posted: Wed Jul 22, 2009 16:48
by Paul Agaliotis
Sorry Joe,
I don,t have any 5gal wing tanks around. I do have a few gauge castings laying around if someone were to try and make the standard nose tanks.
Paul
Posted: Wed Jul 22, 2009 16:52
by 15A
Thanks anyhow Paul.
You always seem to be there forever lending a hand!
There has to be a tank somewhere between these two puddles...