Page 1 of 1
Ident Plate Location
Posted: Mon May 02, 2005 08:08
by Flyboy2
Where is the standard Ident plate location on a 7AC? It's been so long since I took it off I can't remember. NC85411 will be airborne and good for another 60 years in about 2 weeks.
Gary DeBaun
Lakeville, MN
Posted: Mon May 02, 2005 17:50
by Don Eide
Gary,
In the Service and Parts Manual book I have, under Figure 19 Fixed Equipment Installation, It shows that the ID Plate is attached to the floor just in front of the Right Aileron Bellcrank Cover and in a bit from the right Longeron. No measurements are given, but it looks like about 3/4 inch or so from each.
Hope this helps,
Data Plate
Posted: Tue May 03, 2005 07:57
by Flyboy2
Thanks Don, I'll be flying her over for the burger nights here shortly...
Gary