National Aeronca Association Bulletin Board

I just dug out a Wright-Morehouse engine used on the Roche Light Plane, the prototype C2 Aeronca. I have some new crankshaft forgings, rod forgings and rocker arm stand-offs most of the parts needed. But I am in need of some of the smaller parts and a couple of aluminum castings. If you know of anyone that has some of these engine parts for sale or to reverse engineer. I'm in the market.
If I can't locate parts I can only build up a static display, I don't see wasting time on a static piece. I would like to make this a running example.
Paul

Paul,

Will keep my eyes open for this but boy are they few and far in between.

Joe A

Paul , This does not address the Morehouse engine , but I'm having trouble with getting messages through on this site . You had contacted me about A-65-3 cyl & pist on this site and for some reason your message then disappeared off the message board . You asked what size -8 cyl & pist I was looking for and I replied
" as close to std as possible with having to get into a major rework and rechroming to get a useable set " . Then , no reply and your message was gone ? Let me know what you have if you're still interested , Gene

Gene,

You do not have to message through the board. Click on the "email" icon at the bottom of every post and it will send an email directly to anyone who is registered on the board.

Joe A

joea wrote:Gene,

You do not have to message through the board. Click on the "email" icon at the bottom of every post and it will send an email directly to anyone who is registered on the board.

Joe A

Uh, there aint no "email" button.

What I see is "profile" , "PM", and "quote"

Shorty,
I think he meant the PM option. It just keeps the clutter from the board.
Paul