Page 1 of 1
Damaged Wing Ribs
Posted: Sun Aug 07, 2005 22:43
by Paul Agaliotis
I,m looking for wing ribs that are bent,broken,crushed or just trash. I have rib fixtures that allow me to splice all the good parts back together. So if you have any ribs you would like to part with, you can send me a PM or call at (408)683-4751. Thanks, Paul
Posted: Mon Aug 08, 2005 00:36
by joea
Paul,
Sure am glad to see someone able to use the old ribs. I know of some here in Phoenix and will try to get them for you.
JoeA
Posted: Mon Aug 08, 2005 17:33
by Paul Agaliotis
Thanks Joe, let me know the details for the transaction. I can remember when we used to throw away cylinders because they were cracked. But with all of these new-fangled repairs out there it seems there is not too much that cant be repaired. Paul
Re: Damaged Wing Ribs
Posted: Sun Aug 14, 2005 17:51
by shorty
Paul Agaliotis wrote:I,m looking for wing ribs that are bent,broken,crushed or just trash. I have rib fixtures that allow me to splice all the good parts back together. So if you have any ribs you would like to part with, you can send me a PM or call at (408)683-4751. Thanks, Paul
Seems to me, that if you've got all the rib fixtures. You should be able to fabricate new ones instead of having to repair old broken ones.
Am I thinking wrong?
Posted: Sun Aug 14, 2005 18:47
by Paul Agaliotis
The fixture,s I have are for repairing the rib. It allows the rib to stay dimensionally correct during the repair proceedure. The fixtures you refer to would be stamping dies for manufacturing of ribs, which you could not produce without PMA. Paul
Re: Damaged Wing Ribs
Posted: Mon Aug 15, 2005 09:33
by joea
[/quote] Seems to me, that if you've got all the rib fixtures. You should be able to fabricate new ones instead of having to repair old broken ones.
Am I thinking wrong?[/quote]
Shorty, with the pre-war wooden ribs that is correct but making a stamped metal rib would be a different story. This would require a large metal press and lot of setup time and work.
JoeA