Can someone direct me to pictures of the Champ rear panel. I need details of how the elevator cables exit the rear panel.
My project has a real Micky Mouse mess under and behind the rear seat.
Thanks
Paul
N83803
N1431A
2AZ1
Champ rear panel
- Mikek
- Posts: 594
- Joined: Sat Nov 13, 2004 21:13
- Location: Yellow Springs, Ohio 45387 [3OH0]
- Contact:
Re: Champ rear panel
it should show in the manual.
From the the rear stick the top cable comes out of the boot goes on top of the floor under the rear seat to the back panel.
The rear panel has a 2-3 in slot that goes to the floor and the cable runs close to the floor to the rear. The lower cable stays below the floor until it passes under seat then angles up through the rear floor panel which has a 2-3 square hole then follows the other cable to the rear.
Mike K
From the the rear stick the top cable comes out of the boot goes on top of the floor under the rear seat to the back panel.
The rear panel has a 2-3 in slot that goes to the floor and the cable runs close to the floor to the rear. The lower cable stays below the floor until it passes under seat then angles up through the rear floor panel which has a 2-3 square hole then follows the other cable to the rear.
Mike K
Mike Knemeyer
1410 Meadow Lane
Yellow Springs,Ohio 45387
3oh0
N83348 7AC-2015
N82146 7AC-772
1410 Meadow Lane
Yellow Springs,Ohio 45387
3oh0
N83348 7AC-2015
N82146 7AC-772
- RRHaldeman
- Posts: 241
- Joined: Sat Nov 28, 2009 11:07
- Location: Mt Juliet, TN
- Contact:
Re: Champ rear panel
I just posted two photos in my Photobucket album that show the cables behind the rear seat in my 7AC. Hope these will help. You can see them here: http://s900.photobucket.com/albums/ac207/RRHaldeman/
Dick Haldeman, RRHaldeman AT aol DOT com
Cell (815) 222-9812
1946 7AC-2407 N83729
Cell (815) 222-9812
1946 7AC-2407 N83729
-
pmanton
- Posts: 121
- Joined: Sat Oct 29, 2011 10:42
- Location: Indian Hills Airpark Salome, AZ
- Contact:
Re: Champ rear panel
Thanks a million
The chap who did the interior of my Champ made a couple of boxes or tunnels to enclose the elevator cables. I'll make a new back panel and throw the rest of the stuff away.
Paul
N83803
N1431A
2AZ1
Paul
N83803
N1431A
2AZ1
Re: Champ rear panel
I obtained a simple field approval to install a cover over the lower elevator cable and hole in the floor to help prevent stuff from falling through the hole. Photo taken before attachment screws were installed in the cover.
John Propst
313 Hickory Grove Ln
Elizabeth, WV 26143
cell 304 588 3690
j.e.propst@ieee.org
N3129E 2WV3
313 Hickory Grove Ln
Elizabeth, WV 26143
cell 304 588 3690
j.e.propst@ieee.org
N3129E 2WV3