National Aeronca Association Bulletin Board

I have the most current DVD with drawings, but I am in need of the following drawings that are not on the DVD.

3-434 - Assembly – Landing Gear Axle (See 7-807)
3-435 – Assembly – Landing Gear Axle Upper End (See 7-807)
7-451 – Assembly – Landing Gear One Piece Axle Strut (See 7-807)
7-807

If anyone has one, or more, or knows where I can look, I'd appreciate it. My left upper gear axle needs a bushing as the hole for the AN 6-15 hole is no longer round. The drawings might help.

Dick-

I have made inquiries of people I kow that have other drawings in hope that we can find these.

Richard

Just looked and I do not have any of the blueprints above.

Sorry...

Joe A

Dick-

I have sent 7-807B to your email address

The other drawings have not been located. Are you sure of the numbers?

Richard

Dick'
If that bushing hole isn't round any more, check that axle real close. Most of the axles that have been in an accident can tweet that hole into an oval. Check it for cracks pretty close. I replaced my upper bushings and I believe I got them from Univair.
Paul