engine panel moved to PILOTS instrument panel.

Post-War Aeronca Champ airplanes
Post Reply
sevenacjack
Posts: 35
Joined: Wed Mar 02, 2011 07:39
Location: grass strip abilene tx
Contact:

engine panel moved to PILOTS instrument panel.

Post by sevenacjack »

Has anyone out there have any data/thoughts on moving magneto switch, carb heat cable, and fuel shut off to the instrument panel area where it's at a normal position for the PILOT to operate? I recently bought a 7AC Champ with the carb heat and mag switch (toggle switch's) on the instrument panel, "I like em there" I am considering moving the fuel shut off up where I can see and reach it with ease, does anyone have a champ set up like this? thoughts/advice. thanks
User avatar
Richard Murray
Posts: 737
Joined: Fri Nov 02, 2012 06:12
Location: Montezuma, OH (CQA)
Contact:

Re: engine panel moved to PILOTS instrument panel.

Post by Richard Murray »

My 7CCM has everything on the front instrument panel. It was like that when I purchased it and I kept it there after recovering the fuselage and replacing the instrument panel.
Richard
sevenacjack
Posts: 35
Joined: Wed Mar 02, 2011 07:39
Location: grass strip abilene tx
Contact:

Re: engine panel moved to PILOTS instrument panel.

Post by sevenacjack »

Was there anything put in the log books about the engine panel moved to the instrument panel? my thinking is these old airplanes still under CAR 4a, but ya gotta be careful what you do. thanks
Paul Agaliotis
Posts: 2589
Joined: Wed Dec 08, 2004 18:49
Location: San Martin, California
Contact:

Re: engine panel moved to PILOTS instrument panel.

Post by Paul Agaliotis »

I'm sure you could do it, and have seen some aircraft with this modification. You would need to placard this as a "Front Seat Solo" only. Adding a operational limitation placard to the aircraft is something you would need to ask a DAR.

Paul
Mailing Adress : Paul Agaliotis 2060 E. San Martin, San Martin,Calif. 95046
sevenacjack
Posts: 35
Joined: Wed Mar 02, 2011 07:39
Location: grass strip abilene tx
Contact:

Re: engine panel moved to PILOTS instrument panel.

Post by sevenacjack »

Paul, the champ was already placarded "Solo front seat only" I'm going to move the fuel shutoff to the front and make an entry to that effect in the engine log, I've discussed this with a couple AI's I know, and they seem ok with it. I know there are some Champs out there with the engine panel up front like most airplanes of that vintage, and thought I'd toss it out to see what thoughts there were on the mod. thanks, Jack
Paul Agaliotis
Posts: 2589
Joined: Wed Dec 08, 2004 18:49
Location: San Martin, California
Contact:

Re: engine panel moved to PILOTS instrument panel.

Post by Paul Agaliotis »

Jack,

That would be the perfect thing to do. Carl and I walked down the rows of Aeroncas at Middletown and I told him they all had to meet the same type design. He said, "but they're all different". So it comes down to you and your inspector, find the middle ground and keep flying.

Paul
Mailing Adress : Paul Agaliotis 2060 E. San Martin, San Martin,Calif. 95046
sevenacjack
Posts: 35
Joined: Wed Mar 02, 2011 07:39
Location: grass strip abilene tx
Contact:

Re: engine panel moved to PILOTS instrument panel.

Post by sevenacjack »

Paul, good advice, think I'll take that road. thanks
sevenacjack
Posts: 35
Joined: Wed Mar 02, 2011 07:39
Location: grass strip abilene tx
Contact:

Re: engine panel moved to PILOTS instrument panel.

Post by sevenacjack »

The carb heat and A7 ignition switch on front instrument panel left side add-on, and I left the fuel shut off where it was, log book entry, works for me. Jack
Post Reply