National Aeronca Association Bulletin Board

I have a 7GC with a 19 gallon tank in each wing. The resistive type fuel senders need to be replaced as they are both acting up. Does anyone know what the part number is for these units or what the number is for a Stewart Warner or other manufactures equivalent?

Thanks

I already have the two individual Cleveland model 10-5 cylinders mounted and plumbed to the brakes. It all works well but I can't figure out how those levers at the back of the cylinders are rigged to the parking brake cable. I also suspect that there is some form of return spring that has to pull b...

I am trying to install parking brakes on a 7GC airframe. The individual Clevland master cylinders for each brake were original and worked fine but I never had the parking brake working. Most of the parts are there but I think that there is a pair of return springs missing that assist in pulling the ...

Yes, I have the no-bounce gear available and will call you at the number provided.

What would be a good day & time (what time zone are you in)?

I have a few 7GC parts available for sale: - Complete set of No-Bounce landing gear in excellent condition (oleo case frames, axles, shock struts, new seals & springs). - 7GC Data Plate & Logs - Engine mount from 7GC. Used on Lycoming 0-290 (NDT'd and painted) ready to bolt on. - Good front ...

I am recovering the wings on my experimental built Citabria and am considering reducing the wing dihedral from the standard 2 degrees to 1 degree (similar to a Decathalon). All of the wing and fuselage strut attach points and hardware in my A/C are exactly the same as any standard 7-series Champ (Ci...

I have a dataplate tag and original logbooks from a 7GC that I parted out a few years back.

If anyone needs a set I am open to offers.

All of the following parts are from a 7GC aircraft and are in excellent condition: - Complete set of serviceable ready to install No-Bounce landing gear (oleo case frames, landing gear axles, shock struts, new seals & springs). All of these parts new will cost almost $5k, make me an offer! - Fro...

As my aircraft is licensed as 'Amateur Built' in Canada I do not require a STC to install this gear. I fly off some pretty rough areas and this gear would definetly benefit the aircraft. If anyone knew where I could get a set of drawings that could be used to build this style of gear please let me k...

I have tried to get Carl to build me up a set but no luck so far. Does anyone know if there is a set of drawings available to build the gear from?

I am looking for any photographs that show Carl Bahn's landing gear installed on a Champ. I have heard that there are a couple in Alaska. If anyone has some, or can direct me where I can view some photos it would be greatly appreciated.

Thanks

Do you know of anyone who has a used set of Carl's gear for sale as I am having difficulty contacting him. Also, could you send me your phone number as I would like to ask you a few questions about your experience with the gear. Thanks for the help. Does anyone know how much $ a set of Carl's gear s...

Thanks for the info. Does anyone know where I can pick up a set of gear like this, either new or used?

I am looking for any information and pictures of Super Cub style of landing gear that has been installed on a Champ airframe. If anyone has done this modification I would appreciate finding out how well it performed, good or bad experiences, etc.

I am looking for any information that is available on the adjustable :?: ring that is located just forward of the static port on Champ aircraft. The aircraft I have is missing this ring and I need to know its dimensions (diameter & width) and recommended location on the static line attached to t...