National Aeronca Association Bulletin Board

WIth the above post, I emailed Monte and he says the decals are on clear stock and they are pre-die cut ready to go. He's mailing a set directly to Sensenich to put on my prop refinish.

Good post Mark. Thanks for sharing this valuable resource

And to update to 2021. They also upgraded the tip color to the newer color they are using, which has a more tan feeling to it. The prop was sanded, a couple of screws were unsoldered and tightened down, a new front layer was added to replace the one that was dented in after 25 years of annual inspections and the cost was around $640 plus shipping back and forth. It was beautiful when they sent it back. The way you see that you need screws tightened is looking for a little half moon developing in the solder dot in the leading edge tipping. Easy to miss if you don't know what to look for.