National Aeronca Association Bulletin Board

Does anyone have a Trim Tab Bracket drawing or better yet a Trim Tab Bracket for sale. My 11CC project is without the bracket and I don't find one on Todd Trainers disk.

I have a friend who has a few sets of EDO Floats that he is asking $6500.00 for. He may go less if you ask. But he does not have any of the hardware. His name is Jim and he can be reached at 425-330-8401
Bart

I'm working on an 11CC and it has the standard gear, I am assuming that is the way it came. There seems to be a additional cross braces in the wing from the AC , That's about all I can tell you. Hope it helps.
Bart

A Friend of mine has 4 sets of EDO 1340 floats for sale. No hardware just floats, he is asking $6500/pair if anyone is interested.
His phone number is:425-330-8401 ask for Jim!

I went to Brown Bearing in Spokane, WA and they were able to cross reference something close. The Cast Bracket took a KP4A which is still made, and is American. The other bearings are close but do not have the sholder as the Nice bearings. They crossed to a KYK Corp. 1602 ZZ. This is a chineese bear...

Brian & Jim
Thanks for the help. I'm new at using the website and new to rebuilding airplanes. So every bit helps. I found a great deal of information on Trammeling and I think I know what I need to do.
Bart

I am in the process of rebuilding my wings. I had a A&I stop by and he told me I needed to find out how much washout I needed to build into my wing. Also that I needed to setup my drag and anti-drag wires to allow twist in the wing. I have spoken with other people and have been told that the Are...

Have you made any progress with putting juice brakes in the Chief?

Charles
Those are the dimensions of the bearing I have.
Thanks
Bart

Charles I blew up the drawing 2-689 and its easier to read. It looks like there were alternative bearings on the sheet that I could not read. They are Schat CS 2170, Nice 1602 , Nice 402-2, and Nice 641B do any of them cross in your catalog? I think from the description I might have a Nice 402-2 sin...

Mike
I found a Dixie Aerospace Bearing in Peachtree GA. could this be the supplier you suggested?
Thanks
Bart

Thanks. I called Univar after I read your posting but they were not able to cross what I have.

I am restoring a 48 11CC. I just started on the wings. I pulled up the drawings for the aileron hinges and all 3 of them are shown to be the K4A Bearing. However when I dissembled them only the one on the Bellcrank was of the K4A type the other 2 are smaller in diameter 11/16 vs 3/4 and are almost t...

I am a fairly new member, but have not been on the bulletin board until now. I live in the Monroe Area and am restoring an 11CC as well. I would like to vist your project some time if possible.
Bart