National Aeronca Association Bulletin Board

Anything left?

Champ Dreamer wrote:Never mind. Found one, installed it this afternoon, tracking within 1/16". Will test fly in the morning.

Thanks!

Brian walker
'46 7ac/dc

Well how is it now??

I do know of one fellow who had no-bounce gear on his Champ but lack the proper placards and the FAA wrote the fellow a letter saying that his plane was never properly changed, so as far that particular FAA office was concerned, it did not meet the new limits of the type certificate and could stay ...

I'm 'sorta' looking for a good serviceable altimter for my L16. The one I have in it now is (according to Al) from an early Bonanza and ugly brown colored. It works Ok but doesn't match the rest of the dash instruments. It looks like the knob could be located at either the 6 or 7 0 clock position (...

7gcbm wrote:Looking for a complete set of no bounce gear for Champ project. Gary G 651-470-5901

Not easy to find but they do show up from time to time

[quote="pmanton"]Does anyone have any Stromberg NA-S3A1 mixture control part they would part with. I need both discs, the shaft , operating arm and spring.

Paul

pmanton at tds dot net[/
I will look, but keep asking

it should show in the manual. From the the rear stick the top cable comes out of the boot goes on top of the floor under the rear seat to the back panel. The rear panel has a 2-3 in slot that goes to the floor and the cable runs close to the floor to the rear. The lower cable stays below the floor u...

mike newall wrote:My buddy in Florida has found a crack on a Cleveland wheel.

Mike

Inner half with the Drum?

All I can say is "WOW". Boy, with that jig, you could really have a nice straight fuselage. Sorry about your young friend. Thanks for the photos. Mike Same here "WOW" & "Sorry" I can agree nice jig and very complete down to the all the tabs. It would be worth the t...

Hi Mike: Its sunny, We traded rear fuel tank info, I am about ready to send in the 337,on my rear tank installation. I need a fuel valve, On/off type with the mounting ears. The valve your talking about, could sure use probably 2 that would give me a spare, I need some contact info, for Walt? I did...

7ECjim wrote:Any out there?

Sorry looked and I have the inner with drum

7ECjim wrote:Hello all,
I am in the need of a outer cleveland mechanical wheel half. Anyone out there with one?
Thanks Jim

I will check tomorrow not sure which half I still have, but you might want to keep looking just in case.

Here is what my A&P has to say, does it sound reasonable or is there some other problems at hand? Does any one have any suggestions? Hi Skookum, Your airplane overall is in reasonable condition, but typical to all of its type the first in depth annual can be a prolonged event. Ultimately this r...

I only bring this up for information for anyone who might be interested in some kind of alternative. Mike Berg Sounds like a good deal, I have the same deal here at 3oh0. We are a club, own 50 acre with two runways grass & hard 2000 ft. We have about 140 members, of which 25% are active and 90%...

Champ Dreamer wrote:Mike,

Is there a difference between the 65 and 85 airbox? I believe the carbs are the same. I would be tickled to fix both, if it'll work. I'll check on my end.

Thanks,
Brian

Will check on this end also